TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2252-04 Machine Articula-
System Response:
tion Angle Sensor #2 Volt-
ECM will log a diagnostic code.
age Below Normal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 2252-04
is Active.
1. Connect MSD (WP 0006), select
0041-03 or 0041-04 Code Active -
Diagnose 0041-03 or 0041-04 (WP
Trans/chassis 120M and verify
0026) for the Implement ECM first.
0041-03 or 0041-04 are active.
0041-03 or 0041-04 Code Not Active
- Proceed to step 2.
2252-04 Code Active - Proceed to
2. Using MSD (WP 0006), verify
Test Step 2.
2252-04 is active for the transmis-
sion ECM or the Implement 1
2252-04 Code Not Active -
ECM.
Troubleshooting complete.
Test Step 2. Check Articulation
Angle Position Sensor 2 (Right).
1. Disconnect secondary steering
harness connector AT-C4 (WP
0009, Figure 122) from articula-
tion angle position sensor 2 (right)
(WP 0009, Figure 123) (WP
0257).
2. Using MSD (WP 0006), verify
2252-04 Code Active - Proceed to
2252-04 is active.
Test Step 3.
2252-04 Code Not Active - Replace
articulation angle position sensor 2
(right) (WP 0257).
Proceed to step 3.
3. Using MSD (WP 0006), select
2252-04 Code Active - Repeat
Implement 120M and verify 2252- troubleshooting from the beginning of
04 is active.
this diagnostic code.
2252-04 Code Not Active -
Troubleshooting complete.
0031-139