TM 5-3805-293-23-2
0030
Table 1. Implement Code (2169-03 to 2182-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2174-05 Wheel Lean Right
Test Step 3. Test for Open Cab
Solenoid Current Below Nor- Lower Wiring Harness.
mal - Continued
1. Disconnect cab lower wiring har-
ness connector P-C41 (WP 0009,
Figure 68) from implement 1 ECM
J1 (WP 0009, Figure 69) (WP
0268).
2. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
sure for continuity between cab
Replace implement 1 ECM (WP
lower wiring harness connector P-
0268).
C41 (WP 0009, Figure 68) termi-
Remove jumper wire between front
nal 68 and terminal 55.
attachment wiring harness connector
Resistance should be less than
U-C19 (WP 0009, Figure 230)
5.0 ohms.
terminal 1 and terminal 2.
Connect front attachment wiring
harness connector U-C19 (WP 0009,
Figure 230) to wheel lean right
solenoid (WP 0009, Figure 231) (WP
0180).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Proceed to Test Step 4.
3. Using MSD (WP 0006), select
2174-05 Code Active - Repeat
implement 120M ECM and verify
troubleshooting code from the
2174-05 is not active.
beginning.
2174-05 Code Not Active -
Troubleshooting complete.
Test Step 4. Test for Open Front
Attachment Wiring Harness.
1. Disconnect front attachment wir-
ing harness connector U-C1 (WP
0009, Figure 121) from cab lower
wiring harness connector P-C50
(WP 0009, Figure 120) (WP
0180).
0030-44
