TM 5-3805-293-23-2
0030
Table 1. Implement Code (2169-03 to 2182-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2174-05 Wheel Lean Right
System Response:
Solenoid Current Below Nor- ECM will log diagnostic code.
mal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Test for Active Code.
1. Using MSD (WP 0006), select
2174-05 Code Active - Proceed to
implement 120M and verify 2174-
Test Step 2.
05 is active.
2174-05 Code Not Active -
Troubleshooting complete.
Test Step 2. Test for Faulty Wheel
Lean Right Solenoid.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect front attachment wir-
ing harness connector U-C19
(WP 0009, Figure 230) from
wheel lean right solenoid (WP
0009, Figure 231) (WP 0180).
3. Connect jumper wire between
front attachment wiring harness
connector U-C19 (WP 0009, Fig-
ure 230) terminal 1 and terminal
2.
4. Using MSD (WP 0006), select
2174-06 Code Active - Replace
implement 120M and check if
wheel lean right solenoid (WP 0245).
code 2174-06 becomes active.
Proceed to step 5.
2174-05 Code Remains Active -
Proceed to Test Step 3.
5. Using MSD (WP 0006), select
2174-05 Code Active - Repeat
implement 120M ECM and verify
troubleshooting code from the
2174-05 is not active.
beginning.
2174-05 Code Not Active -
Troubleshooting complete.
0030-43
