TM 5-3805-293-23-2
0030
Table 1. Implement Code (2169-03 to 2182-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2173-05 Wheel Lean Left
2. Disconnect front attachment wir-
ing harness connector U-C18
mal - Continued
(WP 0009, Figure 228) from
wheel lean left solenoid (WP
0009, Figure 229) (WP 0180).
3. Connect jumper wire between
front attachment wiring harness
connector U-C18 (WP 0009, Fig-
ure 228) terminal 1 and terminal
2.
4. Using MSD (WP 0006), select
2173-06 Code Active - Replace
implement 120M and check if
code 2173-06 becomes active.
Proceed to step 5.
2173-05 Code Remains Active -
Proceed to Test Step 3.
5. Using MSD (WP 0006), select
2173-05 Code Active - Repeat
implement 120M ECM and verify
troubleshooting code from the
2173-05 is not active.
beginning.
2173-05 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Open Cab
Lower Wiring Harness.
1. Disconnect cab lower wiring har-
ness connector P-C41 (WP 0009,
Figure 68) from implement 1 ECM
J1 (WP 0009, Figure 69) (WP
0268).
Resistance Less Than 5.0 Ohms -
Replace implement 1 ECM (WP
lower wiring harness connector P-
0268).
C41 (WP 0009, Figure 68) termi-
Remove jumper wire between front
nal 67 and terminal 55.
attachment wiring harness connector
U-C18 (WP 0009, Figure 228)
5.0 ohms.
terminal 1 and terminal 2.
Connect front attachment wiring
harness connector U-C18 (WP 0009,
Figure 228) to wheel lean left solenoid
(WP 0009, Figure 229) (WP 0180).
Proceed to step 3.
Proceed to Test Step 4.
0030-36