TM 5-3805-293-23-2
0030
Table 1. Implement Code (2169-03 to 2182-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2173-03 Wheel Lean Left
sure for continuity between front
attachment wiring harness (WP
mal
attachment wiring harness con-
0180).
nector U-C1 (WP 0009, Figure
Connect cab lower wiring harness
121) terminal 9 and all other U-C1
connector P-C41 (WP 0009, Figure
terminals. There should be no
68) to implement 1 ECM J1 (WP
continuity.
0009, Figure 69) (WP 0268).
Proceed to step 3.
wiring harness (WP 0266).
Connect front attachment wiring
harness connector U-C18 (WP 0009,
Figure 228) to wheel lean left solenoid
(WP 0009, Figure 229) (WP 0180).
Proceed to step 3.
3. Using MSD (WP 0006), select
2173-03 Code Active - Repeat
implement 120M ECM and verify
troubleshooting code from the
2173-03 is not active.
beginning.
2173-03 Code Not Active -
Troubleshooting complete.
System Response:
2173-05 Wheel Lean Left
Solenoid Current Below Nor- ECM will log diagnostic code.
mal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Test for Active Code.
1. Using MSD (WP 0006), select
2173-05 Code Active - Proceed to
implement 120M and verify 2173-
Test Step 2.
05 is active.
2173-05 Code Not Active -
Troubleshooting complete.
Test Step 2. Test for Faulty Wheel
Lean Left solenoid.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
0030-35