TM 5-3805-293-23-2
0029
Table 1. Implement Code (2160-03 TO 2168-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2162-05 Blade Left Lower
7. Using MSD (WP 0006), select
2162-05 Code Active - Repeat
Solenoid Current Below Nor-
Implement 120M and verify 2162- troubleshooting code from the
mal - Continued
05 is active.
beginning.
2162-05 Code Not Active -
Troubleshooting complete.
Test Step 3. Test Cab Lower
Harness.
1. Disconnect front attachment har-
ness connector U-C1 (WP 0009,
Figure 121) from cab lower har-
ness connector P-C50 (WP 0009,
Figure 120).
2. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
3. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Proceed to step 4.
nector U-C1 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
121) terminal 19 and terminal 39.
Replace front attachment wiring
Resistance should be less than
harness (WP 0180).
5.0 ohms.
Connect cab lower harness connector
P-C41 (WP 0009, Figure 68) to
implement 1 ECM J1 (WP 0009,
Figure 69).
Proceed to step 8.
4. Remove jumper wire between
harness connector U-C24 (WP
0009, Figure 240) terminal 1 and
terminal 2.
5. Install jumper wire between har-
ness connector P-C50 (WP 0009,
Figure 120) terminal 20 and termi-
nal 39.
6. Disconnect cab lower harness
connector P-C41 (WP 0009, Fig-
ure 68) from implement 1 ECM J1
(WP 0009, Figure 69) (WP 0268).
0029-21
