TM 5-3805-293-23-2
0029
Table 1. Implement Code (2160-03 TO 2168-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2162-03 Blade Left Lower
6. Using MSD (WP 0006), select
2162-03 Code Active - Repeat
Solenoid Voltage Above Nor-
Implement 120M and verify 2162- troubleshooting code from the
mal - Continued
03 is active.
beginning.
2162-03 Code Not Active -
Troubleshooting complete.
Test Step 3. Test Cab Lower Wiring
Harness.
1. Disconnect front attachment har-
ness connector U-C1 (WP 0009,
Figure 121) from cab lower har-
ness connector P-C50 (WP 0009,
Figure 120).
2. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C41 (WP 0009, Figure
Connect front attachment harness
68) terminal 61 and all other ter-
connector U-C24 (WP 0009, Figure
minals on harness connector P-
240) to blade left lower solenoid (WP
C41.
0009, Figure 241), and install rear
There should be no continuity.
front frame cover (WP 0224).
Proceed to step 3.
No Continuity - Replace front
attachment wiring harness (WP
0180).
Connect cab lower harness connector
P-C41 (WP 0009, Figure 68) to
implement 1 ECM J1 (WP 0009,
Figure 69).
Proceed to step 3.
3. Using MSD (WP 0006), select
2162-03 Code Active - Repeat
Implement 120M and verify 2162- troubleshooting code from the
03 is active.
beginning.
2162-03 Code Not Active -
Troubleshooting complete.
0029-19
