TM 5-3805-293-23-2
0029
Table 1. Implement Code (2160-03 TO 2168-13) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2161-06 Blade Right Raise
Test Step 3. Test Cab Lower Wiring
Solenoid Current Above
Harness.
Normal - Continued
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect front attachment har-
ness connector U-C1 (WP 0009,
Figure 121) from cab lower har-
ness connector P-C50 (WP 0009,
Figure 120).
3. Using digital multimeter, test for
Continuity - Replace front
continuity between harness con-
attachment wiring harness (WP
nector U-C1 (WP 0009, Figure
0180).
121) terminal 18 and all other ter-
Proceed to step 6.
minals on harness connector U-
No Continuity - Proceed to step 4.
C1.
There should be no continuity.
4. Disconnect cab lower harness
connector P-C41 (WP 0009, Fig-
ure 68) from implement 1 ECM J1
(WP 0009, Figure 69) (WP 0268).
5. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C41 (WP 0009, Figure
Connect front attachment harness
68) terminal 59 and all other ter-
connector U-C23 (WP 0009, Figure
minals on harness connector P-
238) to blade right raise solenoid (WP
C41 and to machine ground.
0009, Figure 239), and install rear
There should be no continuity.
front frame cover (WP 0224).
Proceed to step 6.
No Continuity - Replace implement 1
ECM (WP 0268).
Connect cab lower harness connector
P-C41 (WP 0009, Figure 68) to
implement 1 ECM J1 (WP 0009,
Figure 69).
Connect front attachment harness
connector U-C1 (WP 0009, Figure
121) to cab lower harness connector
P-C50 (WP 0009, Figure 120).
Connect front attachment harness
connector U-C23 (WP 0009, Figure
238) to blade right raise solenoid (WP
0009, Figure 239), and install rear
front frame cover (WP 0224).
Proceed to step 6.
0029-16