TM 5-3805-293-23-2
0028
Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2146-03 Articulation Lever
2. Disconnect cab lower wiring har-
Position Sensor Voltage
ness connector P-C52 (WP 0009,
Above Normal - Continued
Figure 154) from LH joystick con-
nector J2 (WP 0282).
3. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
Voltage Between 11.5 to 12.5 Volts -
voltage between harness connec-
Replace LH joystick (WP 0282).
tor P-C52 (WP 0009, Figure 154)
Proceed to step 5.
terminal 1 and machine ground.
Voltage Out of Specifications of
Voltage should be between 11.5
11.5 to 12.5 Volts - Proceed to Test
to 12.5 volts.
Step 7.
5. Using MSD (WP 0006), select
2146-03 Code Active - Repeat
Implement 120M ECM and verify
troubleshooting code from the
2146-03 is not active.
beginning.
2146-03 Code Not Active -
Troubleshooting complete.
Test Step 7. Test for Open Cab
Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the cab lower wiring
harness connector P-C48 (WP
0009, Figure 116) from LH joy-
stick connector J3 (WP 0282).
3. Connect jumper wire between cab
lower wiring harness connector P-
C52 (WP 0009, Figure 154) termi-
nal 1 and P-C48 (WP 0009, Fig-
ure 116) terminal 3.
4. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J1 (WP 0009, Figure 69)
(WP 0266).
5. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J2 (WP 0009, Figure 71)
(WP 0266).
0028-8