TM 5-3805-293-23-2
0028
Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2146-02 Articulation Lever
5. Using MSD (WP 0006), select
2146-02 Code Active - Repeat
Position Sensor Data
Implement 120M ECM and verify
troubleshooting code from the
Erratic, Intermittent or Incor-
2146-02 is not active.
beginning.
rect - Continued
2146-02 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Open Cab
Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the cab lower wiring
harness connector P-C48 (WP
0009, Figure 116) from LH joy-
stick connector J3 (WP 0282).
3. Connect jumper wire between cab
lower wiring harness connector P-
C52 (WP 0009, Figure 154) termi-
nal 1 and P-C48 (WP 0009, Fig-
ure 116) terminal 3.
4. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J1 (WP 0009, Figure 69)
(WP 0266).
5. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J2 (WP 0009, Figure 71)
(WP 0266).
6. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
for continuity between cab lower
Proceed to Test Step 4.
wiring harness connector P-C39
Resistance 5.0 Ohms or Greater -
(WP 0009, Figure 70) terminal 26
Replace cab lower wiring harness
and P-C41 (WP 0009, Figure 68)
(WP 0266).
terminal 21. Resistance should be
Proceed to step 7.
less than 5.0 ohms.
7. Using MSD (WP 0006), select
2146-02 Code Active - Repeat
Implement 120M ECM and verify
troubleshooting code from the
2146-02 is not active.
beginning.
2146-02 Code Not Active -
Troubleshooting complete.
0028-3