TM 5-3805-293-23-2
0028
Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2146-04 Articulation Lever
Test Step 3. Test for Shorted Cab
Position Sensor Voltage
Lower Wiring Harness.
Below Normal - Continued
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J2 (WP 0009, Figure 71)
(WP 0266).
Resistance 5.0 Ohms or Less -
Replace cab lower wiring harness
wiring harness connector P-C39
(WP 0266).
(WP 0009, Figure 70) terminal 26
Proceed to step 4.
and machine ground.
Replace implement 1 ECM (WP
5.0 ohms.
0268).
Connect cab lower wiring harness
connector P-C52 (WP 0009, Figure
154) to LH joystick connector J2 (WP
0282).
Proceed to step 4.
4. Using MSD (WP 0006), select
2146-04 Code Active - Repeat
Implement 120M ECM and verify
troubleshooting code from the
2146-04 is not active.
beginning.
2146-04 Code Not Active -
Troubleshooting complete.
0028-11