TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1472-08 Steering Control
3. Disconnect the rear chassis wir-
Position Sensor #2 Abnor-
ing harness connector FA-C21
mal Frequency, Pulse Width
(WP 0009, Figure 124) from
or Period - Continued
transmission ECM J2 (WP 0009,
Figure 112).
4. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J-2 (WP 0009, Figure 71)
(WP 0268).
5. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J-1 (WP 0009, Figure 69)
(WP 0268).
6. Connect jumper wire between P-
C51 terminal 7 and terminal 4
(WP 0009, Figure 118).
7. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between rear chassis
Proceed to Test Step 4.
wiring harness connector FA-C21
Resistance 5.0 Ohms or Greater -
(WP 0009, Figure 124) terminal
Proceed to Test Step 3.
48 and FA-C20 (WP 0009, Figure
113) terminal 45.
Resistance should be less than
5.0 ohms.
Test Step 3. Test for Open Cab
Upper Wiring Harness.
0027-87
