TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0600-03 Main Hydraulic
Test Step 2. Test Hydraulic Oil Tem-
Pump Discharge Pressure
perature Sensor Circuit.
Sensor Voltage Above
1. Turn ignition switch and battery
Normal - Continued
disconnect switch to the OFF
position.
2. Disconnect the rear chassis wir-
ing harness connector FA-C6
(WP 0009, Figure 212) from
hydraulic oil temperature sensor
(WP 0059).
3. Connect jumper wire between
rear chassis wiring harness con-
nector FA-C6 (WP 0009, Figure
212) terminal 1 and terminal 2.
4. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
5. Using MSD (WP 0006), select
0600-03 Code Remains Active -
Implement 120M and check if
Proceed to Test Step 3.
0600-04 becomes active.
0600-04 Code Becomes Active -
Replace hydraulic oil temperature
sensor (WP 0059).
Proceed to step 6.
6. Using the MSD (WP 0006), select 0600-03 Code Active - Repeat
Implement 120M and verify 0600- troubleshooting code from the
03 is not active.
beginning.
0600-03 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Open Cab
Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J1 (WP 0009, Figure 69)
(WP 0268).
0026-89