TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-14 Steering Control
4. Using the MSD (WP 0006), select
1473-14 Code Active - Repeat trou-
Position Sensor #3 Special
Trans/chassis 120M and verify
bleshooting code from the beginning.
Instruction - Continued
1473-14 is not active.
1473-14 Code Not Active - Trouble-
shooting complete.
1482-03 10 Volt Sensor DC
System Response:
Power Supply Voltage
ECM will log a diagnostic code and a
Above Normal
warning will appear on the messenger
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test for 10 Volts at Left
Steering Cylinder Position Sensor.
1. Connect MSD (WP 0006), select
Trans/chassis 120M and verify
1482-03 is active.
2. Turn ignition switch and battery
disconnect switch to the OFF
position.
3. Disconnect the steering position
sensor harness connector UA-C2
(WP 0009, Figure 192) from left
steering position sensor (WP
0009, Figure 193) (WP 0136).
4. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
Voltage OK (9.6 - 10.4 Volts) - 10 Volt
5. Using digital multimeter, measure
power supply from transmission ECM
voltage between UA-C2 (WP
OK. Replace left steering cylinder
0009, Figure 192) terminal 1 and
(WP 0169).
terminal 2 (ground).
Proceed to step 6.
Voltage Not OK - Proceed to Test
Step 2.