TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1482-03 10 Volt Sensor DC
2. Using digital multimeter, test for
Continuity - Steering position sensor
Power Supply Voltage
continuity between steering posi-
harness shorted, replace steering
Above Normal - Continued
tion sensor harness connector
position sensor harness (WP 0136).
UA-C1 (WP 0009, Figure 194) ter-
Connect the rear chassis wiring har-
minal A, and all other terminals.
ness connector FA-C20 (WP 0009,
There should be no continuity.
Figure 113) to transmission ECM J1
(WP 0009, Figure 112).
Connect the front chassis wiring har-
ness connector U-C36 (WP 0009, Fig-
ure 188) (WP 0183) to cab lower
wiring harness connector P-C151
(WP 0009, Figure 189). Proceed to
step 3.
No Continuity - Cab Lower wiring
harness shorted, replace cab lower
wiring harness (WP 0266).
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) to transmission ECM J1
(WP 0009, Figure 112).
Connect the steering position sensor
harness connector UA-C2 (WP 0009,
Figure 192) to left steering position
sensor (WP 0009, Figure 193) (WP
0136).
Connect the steering position sensor
harness connector UA-C1 (WP 0009,
Figure 194) (WP 0136) to front chas-
sis wiring harness connector U-C51
(WP 0009, Figure 195).
Proceed to step 3.
3. Using the MSD (WP 0006), select
1482-03 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1482-03 is not active.
1482-03 Code Not Active - Trouble-
shooting complete.
0019-75