TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1482-03 10 Volt Sensor DC
6. Using the MSD (WP 0006), select
1482-03 Code Active - Repeat trou-
Power Supply Voltage
Trans/chassis 120M and verify
bleshooting code from the beginning.
Above Normal - Continued
1482-03 is not active.
1482-03 Code Not Active - Trouble-
shooting complete.
Test Step 2. Test for 10 Volts at RH
Joystick.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the cab lower wiring
harness connector P-C8 (WP
0009, Figure 50) from RH joystick
connector J-1 (WP 0283).
3. Turn ignition switch and battery
disconnect switch to the ON posi-
tion.
4. Using digital multimeter, measure
Voltage OK (9.6 - 10.4 Volts) - 10 Volt
voltage between P-C8 (WP 0009,
power supply from transmission ECM
Figure 50) terminal 6 and terminal
OK. Replace RH joystick (WP 0283).
8 (ground). Voltage should be
Connect the steering position sensor
between 9.6 and 10.4 volts.
harness connector UA-C2 (WP 0009,
Figure 192) to left steering position
sensor (WP 0009, Figure 193) (WP
0136). Proceed to step 5.
Voltage NOT OK - Proceed to Test
Step 3.
5. Using the MSD (WP 0006), select
1482-03 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1482-03 is not active.
1482-03 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test for Shorted Rear
Chassis Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
0019-72