TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1473-14 Steering Control
7. Connect jumper wire between P-
Position Sensor #3 Special
C48 (WP 0009, Figure 116) termi-
Instruction - Continued
nal 1 and P-C51 and terminal 3
(WP 0009, Figure 118).
8. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between rear chassis
Proceed to Test Step 5.
wiring harness connector FA-C21
Resistance 5.0 Ohms or Greater -
(WP 0009, Figure 124) terminal
Proceed to Test Step 4.
34 and FA-C20 (WP 0009, Figure
113) terminal 21.
Resistance should be less than
5.0 ohms.
Test Step 4. Test for Open Cab
Upper Wiring Harness.
1. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
Rear chassis wiring harness is open,
resistance between cab lower wir-
replace rear chassis wiring harness
ing harness connector P-C69
(WP 0188).
(WP 0009, Figure 46) terminal 51
and terminal 28.
Remove jumper wire between P-C48
Resistance should be less than
(WP 0009, Figure 116) terminal 1 and
5.0 ohms.
P-C51 and terminal 3 (WP 0009, Fig-
ure 118).
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 2.
Resistance 5.0 Ohms or Greater -
Cab lower wiring harness is open,
replace cab lower wiring harness (WP
0266).
Connect the rear chassis wiring har-
ness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) (WP 0154) to transmis-
sion ECM J1 (WP 0009, Figure 112).
Proceed to step 2.
0019-69