• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.

Maintenance Manual For Motorized Road Grader Model 120M - 1
Page Navigation
  1001    1002    1003    1004    1005  1006  1007    1008    1009    1010    1011  
img
. . . . . .
TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0627-04 Parking Brake Pres- 3. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
sure Switch Voltage Below
continuity between harness con-
Replace rear chassis wiring harness
Normal - Continued
nector FA-C20 (WP 0009, Figure
(WP 0188).
113) terminal 40 and all other ter-
Connect harness connector T-C12
minals on harness connector FA-
(WP 0009, Figure 219) to park brake
C20 and to machine ground.
pressure switch (WP 0009, Figure
Resistance should be less than
218).
5.0 ohms.
Proceed to step 4.
Resistance More Than 5.0 Ohms -
Replace park brake pressure switch
(WP 0153).
Proceed to step 4.
4. Connect MSD (WP 0006). Select
0627-04 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
0627-04 is active.
diagnostic code.
0627-04 Code Not Active - Trouble-
shooting complete.
0669-02 Transmission Input
System Response:
Speed Sensor Data Erratic,
ECM will log a diagnostic code.
Intermittent or Incorrect
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Test Sensor and Cir-
cuits.
1. Connect MSD (WP 0006). Select
0669-02 Code Active - Proceed to
Trans/Chassis 120M and verify
step 2.
0669-02 is active.
0669-02 Code Not Active - Trouble-
shooting complete.
2. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
3. Remove transmission input speed
sensor (WP 0149).
0017-105


Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved.