TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0627-04 Parking Brake Pres- 2. Disconnect harness connector T-
sure Switch Voltage Below
C12 (WP 0009, Figure 219) from
Normal - Continued
park brake pressure switch (WP
0009, Figure 218).
3. Using digital multimeter, test for
Resistance 5.0 Ohms or Less - Pro-
continuity between harness con-
ceed to Test Step 3.
nector FA-C20 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
113) terminal 35 and all other ter-
Proceed to step 4.
minals on harness connector FA-
C20 and to machine ground.
Resistance should be less than
5.0 ohms.
4. Using digital multimeter, test for
Resistance 5.0 Ohms or Less - Pro-
continuity between harness con-
ceed to Test Step 3.
nector FA-C20 (WP 0009, Figure
Resistance More Than 5.0 Ohms -
113) terminal 40 and all other ter-
Replace parking brake pressure
minals on harness connector FA-
switch (WP 0153).
C20 and to machine ground.
Proceed to step 5
Resistance should be less than
5.0 ohms.
5. Connect MSD (WP 0006). Select
0627-04 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
0627-04 is active.
diagnostic code.
0627-04 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test Transmission Har-
ness Circuits.
1. Disconnect rear chassis harness
connector FA-C28 (WP 0009, Fig-
ure 129) from transmission wiring
harness connector T-C1 (WP
0009, Figure 130) (WP 0158).
2. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
continuity between harness con-
Replace rear chassis wiring harness
nector FA-C20 (WP 0009, Figure
(WP 0188)
113) terminal 35 and all other ter-
Connect harness connector T-C12
minals on harness connector FA-
(WP 0009, Figure 219) to park brake
C20 and to machine ground.
pressure switch (WP 0009, Figure
Resistance should be less than
218).
5.0 ohms.
Proceed to step 4.
Resistance More Than 5.0 Ohms -
Proceed to step 3.
0017-104