TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0627-03 Parking Brake Pres- 2. Using digital multimeter, test for
Resistance 5.0 Ohms or Less -
sure Switch Voltage Above
continuity between harness con-
Replace park brake pressure switch
Normal - Continued
nector T-C1 (WP 0009, Figure
(WP 0153).
130) terminal 2 and T-C12 (WP
Proceed to step 3.
0009, Figure 219) terminal B.
Resistance More Than 5.0 Ohms -
Resistance should be less than
Replace transmission wiring harness
5.0 ohms.
(WP 0158).
Connect harness connector FA-C20
(WP 0009, Figure 113) to transmis-
sion ECM J1 (WP 0009, Figure 112)
(WP 0137).
Proceed to step 3.
3. Connect MSD (WP 0006). Select
0627-03 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
0627-03 is active.
diagnostic code.
0627-03 Code Not Active - Trouble-
shooting complete.
0627-04 Parking Brake Pres- System Response:
sure Switch Voltage Below
ECM will log a diagnostic code.
Normal
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 0627-04
is Active.
1. Connect MSD (WP 0006). Select
0627-04 Code Active - Proceed to
Trans/Chassis 120M and verify
Test Step 2.
0627-04 is active.
0627-04 Code Not Active - Trouble-
shooting complete.
Test Step 2. Test Rear Chassis Har-
ness Circuits.
1. Disconnect harness connector
FA-C20 (WP 0009, Figure 113)
from transmission ECM J1 (WP
0009, Figure 112) (WP 0137).