TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0623-04 Directional Switch
5. Using digital multimeter, test for
Continuity - Replace rear chassis
Voltage Below Normal - Con-
continuity between harness con-
wiring harness (WP 0188).
tinued
nector FA-C21 (WP 0009, Figure
Proceed to step 14.
124) terminal 23 and all other ter-
No Continuity - Proceed to step 6.
minals on harness connector FA-
C21 and to machine ground.
There should be no continuity.
6. Using digital multimeter, test for
Continuity - Replace rear chassis
continuity between harness con-
wiring harness (WP 0188).
nector FA-C21 (WP 0009, Figure
Proceed to step 14.
124) terminal 28 and all other ter-
No Continuity - Proceed to step 7.
minals on harness connector FA-
C21 and to machine ground.
There should be no continuity.
7. Using digital multimeter, test for
Continuity - Replace rear chassis
continuity between harness con-
wiring harness (WP 0188).
nector FA-C21 (WP 0009, Figure
Proceed to step 14.
124) terminal 29 and all other ter-
No Continuity - Proceed to step 8.
minals on harness connector FA-
C21 and to machine ground.
There should be no continuity.
8. Remove operator's seat (WP
0284).
9. Remove inner panel cover from
left joystick support (WP 0282).
10. Disconnect harness connector P-
C52 (WP 0009, Figure 154) from
left hand joystick J2 (WP 0282).
11. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C69 (WP 0009, Figure
Connect harness connector FA-C21
46) terminal 50 and all other ter-
(WP 0009, Figure 124) to transmis-
minals on harness connector P-
sion ECM J2 (WP 0009, Figure 112).
C69 and to machine ground.
Proceed to step 14.
There should be no continuity.
No Continuity - Proceed to step 12.
12. Using digital multimeter, test for
Continuity - Replace cab lower wiring
continuity between harness con-
harness (WP 0266).
nector P-C69 (WP 0009, Figure
Connect harness connector FA-C21
46) terminal 57 and all other ter-
(WP 0009, Figure 124) to transmis-
minals on harness connector P-
sion ECM J2 (WP 0009, Figure 112).
C69 and to machine ground.
Proceed to step 14.
There should be no continuity.
No Continuity - Proceed to step 13.
0017-96