TM 5-3805-293-23-1
0017
Table 1. Transmission Code (0573-03 to 0967-09) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0623-03 Directional Switch
7. Connect MSD (WP 0006). Select
0622-03 Code Active - Repeat trou-
Voltage Above Normal -
Trans/Chassis 120M and verify
bleshooting from the beginning of this
Continued
0622-03 is active.
diagnostic code.
0622-03 Code Not Active - Trouble-
shooting complete.
0623-04 Directional Switch
System Response:
Voltage Below Normal
ECM will log a diagnostic code.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 0623-04
is Active.
1. Connect MSD (WP 0006). Select
0623-04 Code Active - Proceed to
Trans/Chassis 120M and verify
Test Step 2.
0623-04 is active.
0623-04 Code Not Active - Trouble-
shooting complete.
Test Step 2. Test Directional Switch
Circuits.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Disconnect harness connector
FA-C21 (WP 0009, Figure 124)
from transmission ECM J2 (WP
0009, Figure 112).
N OT E
Harness connector is located behind cab bulkhead cover on right rear
of cab.
3. Remove rear bulkhead cover
plate (WP 0266).
4. Disconnect rear chassis wiring
harness connector FA-C22 (WP
0009, Figure 47) from cab lower
wiring harness connector P-C69
(WP 0009, Figure 46) (WP 0188).