TM 5-3805-293-23-1
0016
Table 1. Transmission Code (0041-03 to 0444-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0168-02 Electrical System
6. Using digital multimeter, test for
No Continuity or Resistance More
Voltage Data Erratic, Inter-
continuity between harness con-
Than 5.0 Ohms - Verify rear frame
mittent, or Incorrect - Con-
nector FA-C20 (WP 0009, Figure
ground (WP 0009, Figure 133) is
tinued
113) terminal 66 and machine
clean and tight. If rear frame ground is
ground.
OK, replace rear chassis wiring har-
Resistance should be less than 5.0
ness (WP 0188).
ohms.
Proceed to step 9.
Continuity - Proceed to step 7.
7. Using digital multimeter, test for
No Continuity or Resistance More
continuity between harness con-
Than 5.0 Ohms - Verify rear frame
nector FA-C20 (WP 0009, Figure
ground (WP 0009, Figure 133) is
113) terminal 67 and machine
clean and tight. If rear frame ground is
ground.
OK, replace rear chassis wiring har-
Resistance should be less than 5.0
ness (WP 0188).
ohms.
Proceed to step 9.
Continuity - Proceed to step 8.
8. Using digital multimeter, test for
No Continuity or Resistance More
continuity between harness con-
Than 5.0 Ohms - Verify rear frame
nector FA-C20 (WP 0009, Figure
ground (WP 0009, Figure 133) is
113) terminal 70 and machine
clean and tight. If rear frame ground is
ground.
OK, replace rear chassis wiring har-
Resistance should be less than 5.0
ness (WP 0188).
ohms.
Proceed to step 9.
Continuity - Replace transmission
ECM (WP 0137).
Proceed to Step 9.
9. Using the MSD (WP 0006), select
0168-02 Code Remains Active -
Trans/Chassis 120M and verify
Repeat troubleshooting from the
0168-02 is not active.
beginning of this diagnostic code.
0168-02 Code Not Active - Trouble-
shooting complete.
0016-37