TM 5-3805-293-23-1
0016
Table 1. Transmission Code (0041-03 to 0444-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0168-02 Electrical System
3. Turn battery disconnect and igni-
Voltage Data Erratic, Inter-
tion switch to the ON position (TM
mittent, or Incorrect - Con-
5-3805-293-10).
tinued
4. Using digital multimeter, test for
Voltage Less Than 18 Volts -
voltage between harness connec-
Replace rear chassis wiring harness
tor FA-C20 (WP 0009, Figure 113)
(WP 0188).
terminal 31 and machine ground.
Proceed to step 10.
Voltage should be between 18 to 26
Voltage OK - Proceed to step 5.
volts.
5. Using digital multimeter, test for
Voltage Less Than 18 Volts -
voltage between harness connec-
Replace rear chassis wiring harness
tor FA-C20 (WP 0009, Figure 113)
(WP 0188).
terminal 38 and machine ground.
Proceed to step 10.
Voltage should be between 18 to 26
Voltage OK - Proceed to step 6.
volts.
6. Using digital multimeter, test for
Voltage Less Than 18 Volts -
voltage between harness connec-
Replace rear chassis wiring harness
tor FA-C20 (WP 0009, Figure 113)
(WP 0188).
terminal 39 and machine ground.
Proceed to step 10.
Voltage should be between 18 to 26
Voltage OK - Proceed to step 7.
volts.
7. Using digital multimeter, test for
Voltage Less Than 18 Volts -
voltage between harness connec-
Replace rear chassis wiring harness
tor FA-C20 (WP 0009, Figure 113)
(WP 0188).
terminal 31 and machine ground.
Proceed to step 10.
Voltage should be between 18 to 26
Voltage OK - Proceed to step 8.
volts.
8. Using digital multimeter, test for
Voltage Less Than 18 Volts -
voltage between harness connec-
Replace rear chassis wiring harness
tor FA-C20 (WP 0009, Figure 113)
(WP 0188).
terminal 46 and machine ground.
Proceed to step 10.
Voltage should be between 18 to 26
Voltage OK - Proceed to step 9.
volts.
9. Using digital multimeter, test for
Voltage Less Than 18 Volts -
voltage between harness connec-
Replace rear chassis wiring harness
tor FA-C20 (WP 0009, Figure 113)
(WP 0188).
terminal 47 and machine ground.
Proceed to step 10.
Voltage should be between 18 to 26
Voltage OK - Proceed to Test Step 2.
volts.
10. Using the MSD (WP 0006), select
0168-02 Code Remains Active -
Trans/Chassis 120M and verify
Repeat troubleshooting from the
0168-02 is not active.
beginning of this diagnostic code.
0168-02 Code Not Active - Trouble-
shooting complete.
0016-35