TM 5-3805-293-23-1
0016
Table 1. Transmission Code (0041-03 to 0444-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0168-01 Electrical System
5. Using digital multimeter, test for
Voltage Less Than 18 Volts -
Voltage Low - Continued
voltage between harness connec-
Replace rear chassis wiring harness
tor FA-C20 (WP 0009, Figure 113)
(WP 0188).
terminal 38 and machine ground.
Proceed to step 9.
Voltage should be between 18 to 26
Voltage Between 18 to 26 Volts -
volts.
Proceed to step 6.
6. Using digital multimeter, test for
Voltage Less Than 18 Volts -
voltage between harness connec-
Replace rear chassis wiring harness
tor FA-C20 (WP 0009, Figure 113)
(WP 0188).
terminal 39 and machine ground.
Proceed to step 9.
Voltage should be between 18 to 26
Voltage Between 18 to 26 Volts -
volts.
Proceed to step 7.
7. Using digital multimeter, test for
Voltage Less Than 18 Volts -
voltage between harness connec-
Replace rear chassis wiring harness
tor FA-C20 (WP 0009, Figure 113)
(WP 0188).
terminal 46 and machine ground.
Proceed to step 9.
Voltage should be between 18 to 26
Voltage Between 18 to 26 Volts -
volts.
Proceed to step 8.
8. Using digital multimeter, test for
Voltage Less Than 18 Volts -
voltage between harness connec-
Replace rear chassis wiring harness
tor FA-C20 (WP 0009, Figure 113)
(WP 0188).
terminal 47 and machine ground.
Proceed to step 9.
Voltage should be between 18 to 26
Voltage Between 18 to 26 Volts -
volts.
Proceed to Test Step 3.
9. Using the MSD (WP 0006), select
0168-01 Code Remains Active - Pro-
Trans/Chassis 120M and verify
ceed to Test 2.
0168-01 is not active.
0168-00 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test Ground (-) Supply
Circuits.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Using digital multimeter, test for
No Continuity or Resistance More
continuity between harness con-
Than 5.0 Ohms - Verify rear frame
nector FA-C20 (WP 0009, Figure
ground (WP 0009, Figure 133) is
113) terminal 13 and machine
clean and tight. If rear frame ground is
ground.
OK, replace rear chassis wiring har-
Resistance should be less than 5.0
ness (WP 0188).
ohms.
Proceed to step 9.
Continuity - Proceed to step 3.
0016-32