TM 5-3805-293-23-1
0016
Table 1. Transmission Code (0041-03 to 0444-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0168-01 Electrical System
3. Using digital multimeter, test for
No Continuity or Resistance More
Voltage Low - Continued
continuity between harness con-
Than 5.0 Ohms - Verify rear frame
nector FA-C20 (WP 0009, Figure
ground (WP 0009, Figure 133) is
113) terminal 23 and machine
clean and tight. If rear frame ground is
ground.
OK, replace rear chassis wiring har-
Resistance should be less than 5.0
ness (WP 0188).
ohms.
Proceed to step 9.
Continuity - Proceed to step 4.
4. Using digital multimeter, test for
No Continuity or Resistance More
continuity between harness con-
Than 5.0 Ohms - Verify rear frame
nector FA-C20 (WP 0009, Figure
ground (WP 0009, Figure 133) is
113) terminal 26 and machine
clean and tight. If rear frame ground is
ground.
OK, replace rear chassis wiring har-
Resistance should be less than 5.0
ness (WP 0188).
ohms.
Proceed to step 9.
Continuity - Proceed to step 5.
5. Using digital multimeter, test for
No Continuity or Resistance More
continuity between harness con-
Than 5.0 Ohms - Verify rear frame
nector FA-C20 (WP 0009, Figure
ground (WP 0009, Figure 133) is
113) terminal 32 and machine
clean and tight. If rear frame ground is
ground.
OK, replace rear chassis wiring har-
Resistance should be less than 5.0
ness (WP 0188).
ohms.
Proceed to step 9.
Continuity - Proceed to step 6.
6. Using digital multimeter, test for
No Continuity or Resistance More
continuity between harness con-
Than 5.0 Ohms - Verify rear frame
nector FA-C20 (WP 0009, Figure
ground (WP 0009, Figure 133) is
113) terminal 66 and machine
clean and tight. If rear frame ground is
ground.
OK, replace rear chassis wiring har-
Resistance should be less than 5.0
ness (WP 0188).
ohms.
Proceed to step 9.
Continuity - Proceed to step 7.
7. Using digital multimeter, test for
No Continuity or Resistance More
continuity between harness con-
Than 5.0 Ohms - Verify rear frame
nector FA-C20 (WP 0009, Figure
ground (WP 0009, Figure 133) is
113) terminal 67 and machine
clean and tight. If rear frame ground is
ground.
OK, replace rear chassis wiring har-
Resistance should be less than 5.0
ness (WP 0188).
ohms.
Proceed to step 9.
Continuity - Proceed to step 8.
0016-33