TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2189-05 Left All-Wheel Drive
8. Using the MSD (WP 0006), select
2189-05 Code Active - Repeat trou-
(AWD) Clutch Reverse Sole-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
noid Current Below Normal -
2189-05 is not active.
2189-05 Code Not Active - Trouble-
Continued
shooting complete.
Test Step 3. Test N820-GY Left AWD
Clutch REV Sol Circuit for High
Resistance or Open in Cab Lower
Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Remove jumper wire from P-C34
terminal 5 and terminal 22 (WP
0009, Figure 52).
3. Disconnect cab lower wiring P-
C37 harness connector (WP
0009, Figure 55) from AWD ECM
J2 (WP 0009, Figure 56) (WP
0270).
4. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
Proceed to Test Step 4.
sure resistance between P-C37
terminal 3 (WP 0009, Figure 55)
Resistance 5.0 Ohms or Greater -
and P-C34 terminal 5 (WP 0009,
Replace cab lower wiring harness
Figure 52).
(WP 0266).
Connect AF-C8 (WP 0009, Figure 82)
on left AWD clutch reverse solenoid
(WP 0009, Figure 83) (WP 0200).
Install nose front frame cover on
machine (WP 0224).
Proceed to step 5.
5. Using the MSD (WP 0006), select
2189-05 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2189-05 is not active.
2189-05 Code Not Active - Trouble-
shooting complete.
0013-68