TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0041-04 8 Volt DC Supply
Code 0041-04 Becomes Inactive -
Voltage Below Normal - Con-
Replace left motor speed harness
tinued
(WP 0202).
Connect AF-C1 (WP 0009, Figure 61)
on AH-C1 (WP 0009, Figure 62) (WP
0202).
Connect AH-C2 (WP 0009, Figure 57)
on right front drive motor speed sen-
sor connector (WP 0009, Figure 58)
(WP 0166).
Install rear front frame cover on
machine (WP 0224).
Install trim cover (WP 0277).
Install operator's seat (WP 0284).
Proceed to step 5.
5. Using the MSD (WP 0006), select
0041-04 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
0041-04 is not active.
0041-04 Code Not Active - Trouble-
shooting complete.
0168-00 Electrical System
System Response:
Voltage High
All-Wheel Drive (AWD) Electronic
Control Module (ECM) will log a diag-
nostic code and a warning will appear
on the messenger while the diagnos-
tic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Test Charging System.
1. Connect MSD (WP 0006). Select
All Wheel Drive 120M and verify
0168-00 is active.
2. Perform charging system tests
Perform corrective action as directed
(WP 0040).
in charging system tests (WP 0040).