3304 VEHICULAR ENGINESSPECIFICATIONSTM 5-3805-263-14&P-2GOVERNOR CONTROL GROUP5R6353LINKAGE ADJUSTMENT PROCEDURE:NOTE: DO NOT use control lever (2) lo shut OFF the engine.To shut engine OFF pull up on accelerator treadle (11)1. Tighten nut (A) lust enough so position of control lever (2) isnot affected by the operation of the accelerator treadle (11)and decelerator treadle (9).2. With the parking brake ON and engine stopped BE SURE dis-connect switch is OFF.3. Remove pin (4).4. Loosen LOW IDLE stop (7) and HIGH IDLE stop (5) so theydo not touch lever (12).5. Move control lever (2) to LOW IDLE position.6. Turn LOW IDLE stop (7) until it touches lever (12) and tightenlocknut (8).7. Adjust length of rod (13) so distance from top of lever (15) tobottom of floor plate (10) is 150 in (38.1 mm) as shown.8. Loosen locknut (14) and adjust length of rod so top of de-celerator treadle (9) is 19 in. (4.6 mm) above floor plate (10)as shown. If machine is equipped with a thick floor insulationpad, (used with enclosed cab), adjust decelerator treadle (9)so top of treadle is 38 in. (9.7 mm) above lop of floor plate andtighten locknut (14).9. Move control lever (2) to HIGH IDLE position.10. Turn HIGH IDLE slop (5) until it touches lever (12) and tightenlocknut (6).11. Loosen locknut (16) and adjust accelerator treadle (11) so thatdistance from bottom of plate on treadle to top of floor plate(10) is 2.38 ± .12 in (60.5 ± 3.0 mm) as shown.12. Move lever (3) to HIGH IDLE position and adjust length ofrod (1) so pin (4) can be installed.13. Install pin (4).1-225
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
