TM 5-3805-261-34
TRANSMISSION MAINTENANCE.
14-2.
Transmission Assembly. (Sheet 3 of 20)
DISASSEMBLY
1.
Remove bolt (1), retainer (2) and
coupling (3, Figure 14-1) from
transmission on torque converter
side.
2.
Install two 1/2-13NC forged
eyebolts (Figure 14-2).
WARNING
Weight of transmission
assembly is approximately
1500 lbs. Use adequate hoist
and sling for lifting.
Failure to follow this
procedure may cause INJURY.
If you are injured, seek
medical aid immediately.
3.
Attach hoist and sling to two
1/2-13NC forged eyebolts and
lifting eyes (54) on transmission
housing.
4.
Lift transmission assembly and
place on wood blocks with torque
converter side down.
5.
Remove hoist and sling.
6.
Remove bolt (4). retainer (5) and
preformed packing (6, Figure
14-3). Discard preformed packing
(6).
7.
Remove five bolts (7) and lock-
washers (8).
8.
Install two 3/8-16NC forcing
screws in one of two bearing
cages (16).
9.
Evenly and gradually tighten two
3/8-16NC forcing screws and
remove one of two items 9 thru 16
as an assembly.
Go to Sheet 4
14-5
Figure 14-1.
Figure 14-2.
Figure 14-3.
