ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_860

ENGINE MAINTENANCE. (cont) - TM-5-3805-261-34_862

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
814

TM 5-3805-261-34 ENGINE MAINTENANCE. 13-6. Balancer Shaft Assembly and Bearings. (Sheet 3 of 4) INSTALLATION NOTE Make sure that the oil holes in bearing sleeves are in alinement with oil holes in cylinder block. 1. Install two bearing sleeves (9). Front of bearing sleeves (9, Figure 13-35) must be 23.64 to 23.68 inches from the front surface of the cylinder block. 2. Install two bearing sleeves (8). The front of bearing sleeves (8) must be 11.42 to 11.46 inches from the front surface of the cylinder block. 3. Using camshaft bearing tool group and ratchet box wrench, install two bearing sleeves (7) in engine block. The bearing sleeve must be .01 to .05 inch inside end of cylinder block after installa- tion. 4. Turn crankcase. No. 1 piston must be in the top center compression position. 5. Install two keys (6) in balancer shafts (4, Figure 13-34)). 6. Install two gears (5). 7. Using engine oil, lubricate two items 6 thru 4 as an assembly (Figure 13-33) and install in cylinder block. 8. Install two thrust plates (2), four washers (3) and bolts (1, Figure 13-32). Go to Sheet 4 13-35

Privacy Statement
Press Release
Contact