TM 5-3805-261-34
ENGINE MAINTENANCE. (cont)
13-2.
Cylinder Block and Liners. (Sheet 3 of 7)
REMOVAL
1. Remove plate (1), preformed packing (2) and gasket
(3, Figure 13-1). Discard preformed packing (2)
and gasket (3). Remove all gasket material
from mounting surfaces.
2.
Remove plug (4), pin (5) and dowels (6 and 7).
3. Remove dowel (8), stud (9) and cup plug (10).
Discard cup plug (10).
4.
Remove two dowels (11, Figure 13-2).
5. Using camshaft bearing tool group and
ratchet box wrench, remove two bearings
(12) and bearing 13).
6.
Remove plugs (14 thru 17) and washer (18).
Discard washer (18).
7.
Remove and discard cup plug (19).
8. Remove two plugs (20), plug (21) and five balls
(22, Figure 13-3).
9.
Using suitable hammer and driver, remove
and discard four orifices (23).
NOTE
Inspect cylinder liners according to procedure in paragraph 3-7.
Do not remove cylinder liners unless required.
10. Using cylinder liner installation tool,
remove items 24 thru 26 as an assembly.
Figure 13-1.
Figure 13-2.
Figure 13-3.
Go to Sheet 4
13-5
