TM 5-3805-261-34
ENGINE MAINTENANCE.
13-2.
Cylinder Block and Liners. (Sheet 5 of 7)
INSTALLATION
3.
Apply primer to insert (27, Figure 13-5).
4.
Apply thin ring of retaining compound around top diameter and outside face of insert (27).
5.
Using installer assembly, tap shaft with suitable hammer. Insure insert (27) is bottomed against
counterbore.
6.
Install four cylinder liners (26) in block (28, Figure 13-3).
7.
Check liner projection. Refer to paragraph 3-7. Make temporary mark on liner and block to permit correct
positioning during final installation.
Figure 13-3.
Go to Sheet 6
13-7
