EARTHMOVING EQUIPMENT COMPONENTS MAINTENANCE. (cont.)

EARTHMOVING EQUIPMENT COMPONENTS MAINTENANCE. (cont.) - TM-5-3805-261-34_814

EARTHMOVING EQUIPMENT COMPONENTS MAINTENANCE. (cont.) - TM-5-3805-261-34_816

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
768

TM 5-3805-261-34 EARTHMOVING EQUIPMENT COMPONENTS MAINTENANCE 12-7. Circle Assembly. (Sheet 5 of 6) INSTALLATION NOTE Be sure jack stand is not supporting circle when measuring clearance. Do not tighten bolts. Use shim(s) as required to obtain 0.020 inch maximum clearance between drawbar, strip and circle at each shoe. 7. Install four strips (20), eight strips (19), 28 shims (18), 24 shims (17), four shoes (16), washers (15), bolts (14), eight washers (13), bolts (12). washers (11) and lock nuts (10, Figure 12-25) in drawbar assembly. 8. Remove hoist and sling. 9. With the shoes (16) and shims (18) in position on drawbar, adjust four shoes (16, Figure 12-27). 10. Loosen nuts (8) on setscrews (9). 11. Tighten setscrews (9) until the shoes are against the inside of the circle. 12. Loosen setscrews (9) until the circle is just free to turn. 13. Tighten nuts (8) on setscrews (9). Figure 12-27. Figure 12-25. Go to Sheet 6 12-33

Privacy Statement
Press Release
Contact