EARTHMOVING EQUIPMENT COMPONENTS MAINTENANCE. (cont.)

EARTHMOVING EQUIPMENT COMPONENTS MAINTENANCE. (cont.) - TM-5-3805-261-34_809

EARTHMOVING EQUIPMENT COMPONENTS MAINTENANCE. (cont.) - TM-5-3805-261-34_811

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
763

TM 5-3805-261-34 Figure 12-19. EARTHMOVING EQUIPMENT COMPONENTS MAINTENANCE. (cont.) 12-6. Blade Brackets. (Sheet 5 of 5) INSTALLATION (cont.) 10. Attach hoist and sling to bracket (9, Figure 12-19). 11. Install two washers (10). Use two washers (10) as required to get sliding fit of bracket (9) with maximum 0.07 inch clearance between bracket (9) and circle wear plate. 12. Install bracket (9). 13. Install bolt (8), washers (7 and 6) and nut (5). 14. Turn nut (12) out to make contact with bracket (9). 15. Install nut (4) and tighten to 1200 ft-lb torque using torque multiplier and torque wrench. 16. Install washer (3) and nut (2). Tighten nut (2) to 0.00 inch clearance and back off enough to permit installation of new cotter pin (1). 17. Install new cotter pin (1). 18. Remove rope and hoist and sling. NOTE Return 13OG Grader to original equipment condition. End of Task 12-28

Privacy Statement
Press Release
Contact