TM 5-3805-261-34
.
Go to Sheet 5
12-32
EARTHMOVING EQUIPMENT COMPONENTS MAINTENANCE. (cont.)
12-7. Circle Assembly. (Sheet 4 of 6)
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter
2.
INSTALLATION
1.
Attach hoist and sling to circle
(21, Figure 12-26) under vehicle.
2.
Raise circle (21) into mounting
position under vehicle.
3.
Support circle (21) with jack
stands.
WARNING
Only a qualified operator may
perform the next procedure.
All other personnel must
clear the immediate area.
Failure to follow this
procedure may cause INJURY.
If you are injured, seek
medical aid immediately.
4.
Start engine. Refer to TM 5-
3805-261-10.
5.
Lower drawbar assembly into
position over circle (21). Move
vehicle slowly forward to engage
circle drive motor pinion into
circle (21).
6.
Stop engine.
Figure 12-26