TM 5-3805-261-34
EARTHMOVING EQUIPMENT COMPONENTS MAINTENANCE.
12-2. Blade Assembly. (Sheet 3 of 5)
REMOVAL
5.
Position wood blocks between
blade bracket and cylinder rod
end (Figure 12-2).
6.
Operate blade sideshift control
and expand cylinder rod to push
blade assembly (3) away from
circle until two eyebolts can be
installed.
7.
Install two eyebolts to blade
assembly (3).
WARNING
Weight of blade assembly is
approximately 1500 lbs. Use
adequate hoist and sling for
lifting. Failure to follow
this procedure may cause
INJURY. If you are injured,
seek medical aid immediately.
8.
Attach hoist and sling to two
eyebolts on blade assembly (3).
9.
Remove blade assembly (3).
Operate blade sideshift control
and expand cylinder rod to push
blade assembly (3) away from
circle.
10. Stop engine.
11. Remove hoist and sling and two
eyebolts.
12. Remove 40 bolts (4), washers (5),
ten plates (6), five strips (7)
and shim(s) (8, Figure 12-3).
Go to Sheet 4
12-5
Figure 12-3.
Figure 12-2.
