TM 5-3805-261-34
EARTHMOVING EQUIPMENT COMPONENTS MAINTENANCE. (cont.)
12-2. Blade Assembly. (Sheet 2 of 5)
REMOVAL
1.
Move blade assembly (3, Figure
12-1) as far to right as possible
and lower until just off the
ground.
2.
Remove cotter pin (1) and pin
(2). Discard cotter pin (1).
WARNING
Only a qualified operator may
perform the next procedure.
All other personnel must
clear the immediate area.
Failure to follow this
procedure may cause INJURY.
If you are injured, seek
medical aid immediately.
3.
Start engine. Refer to TM 5-
3805-261-10.
4.
Operate blade sideshift control
to retract cylinder rod into
cylinder as far as possible.
Figure 12-1.
Go to Sheet 3
12-4