TM 5-3805-261-34
HYDRAULIC SYSTEM MAINTENANCE. (cont)
10-23.
Oil Cooler to Relief Valve and Hydraulic Tank Lines and Fittings.
(Sheet 3 of 9)
REMOVAL
1.
Loosen two clamps (2, Figure
10-166).
NOTE
All hose and tube assemblies
must be tagged before
disconnecting to aid in
installation. Cap all hose
and tube ends and plug all
open hydraulic ports to
prevent contamination.
2.
Remove hose (1) and two clamps
(2) from under right, rear of
cab.
3.
Remove four bolts (3), flange
(4), hose (5) and seal (6) from
bottom, right side of hydraulic
tank. Discard seal (6).
4.
Remove four bolts (7), flange
(8), stem (9) and seal (10) from
hydraulic pump under center of
cab. Discard seal (10).
5.
Disconnect hose assemblies (11,
22, 69 and 72, Figure 10-167)
from bottom of hydraulic tank.
6.
Remove connector (12), preformed
packing (13), connector (14) and
preformed packing (15). Discard
preformed packings (13 and 15).
7.
Remove connector (16), preformed
packing (17), connector (18) and
preformed packing (19). Discard
preformed packings (17 and 19).
8.
Loosen two clamps (21, Figure
10-168).
Go to Sheet 4
10-138
Figure 10-166.
Figure 10-167.
Figure 10-168.