TM 5-3805-261-34
HYDRAULIC SYSTEM MAINTENANCE.
10-22.
Hydraulic Pump and Control Valve Lines and Fittings. (Sheet 2 of 8)
REMOVAL
NOTE
All hose and tube assemblies
must be tagged before
disconnecting to aid in
installation. Cap all hose
and tube ends to prevent
contamination.
1.
Disconnect hose assembly (9,
Figure 10-157).
2.
Loosen elbow locknut on elbow (1)
and remove elbow (1).
3.
Remove preformed packing (2).
Discard preformed packing (2).
4.
Disconnect hose assembly (31)
from right side of vehicle.
5.
Remove connector (3) and
preformed packing (4). Discard
preformed packing (4).
6.
Remove bolt (5), washer (6) and
two clips.
7.
Disconnect hose assembly (12).
8.
Remove connector (7) and
preformed packing (8). Discard
preformed packing (8).
9.
Remove hydraulic pressure switch
(Figure 10-158). Refer to
TM 5-3805-261-20.
10. Remove hose assembly (9),
connector (10) and preformed
packing (11). Discard preformed
packing (11).
11. Remove hose assembly (12),
connector (13) and preformed
packing (14). Discard preformed
packing (14).
Go to Sheet 3
10-129
Figure 10-157.
Figure 10-158.
