TM 5-3805-261-34
HYDRAULIC SYSTEM MAINTENANCE.
10-22.
Hydraulic Pump and Control Valve Lines and Fittings. (Sheet 1 of 8)
This task covers:
a.
Removal
b.
Cleaning
c.
Inspection
d.
Installation
INITIAL SETUP:
Applicable Configurations
Personnel Required
All
Construction equipment
repairer MOS 62B
Tools
General Mechanic’s Tool Kit:
References
Automotive (NSN 5180-00-177-
TM 5-3805-248-10
7033)
LO 5-3805-248-12
Test Equipment
Special Environmental Conditions
None
None
Materials/Parts
General Safety Instructions
Dry cleaning solvent,
None
Item 15, Appendix C
Clean cloths, Item 41
Torques
Appendix C
Except for special torques shown,
Detergent, Item 9, Appendix C
all fasteners are tightened to
Small tags, Item 43,
standard torques. Refer to
Appendix C
Appendix E.
Preformed packings, Items 2,
4, 8, 11, 14, 16, 20, 22,
24, 26, 29, 34, 42, 44, 48,
Troubleshooting References
None
Equipment Condition
TM 5-3805-248-10
Vehicle parked on level ground.
Parking/emergency brake applied.
Equipment lowered to the ground.
Engine stopped.
Master disconnect switch off.
Hydraulic pressure relieved.
Paragraph 3-4
Engine removed.
Go to Sheet 2
10-128
