TM 5-3805-261-34
HYDRAULIC SYSTEM MAINTENANCE. (cont)
10-3.
Hydraulic Pump Assembly and Mounting. (Sheet 3 of 7)
REMOVAL (cont)
12.
Position pump assembly (24) on
left side of pivot area. Slide
items 21 thru 30 as an assembly
(Figure 10-8) from underneath cab
into a position where hoist and
sling can be attached.
Weight of pump assembly is
approximately 159 lbs. Use
adequate hoist and sling for
lifting. Failure to follow
this procedure may cause
INJURY. If you are injured,
seek medical aid immediately.
13.
Attach hoist and sling to items
21 thru 30 as an assembly and
take up slack.
14.
Remove items 21 thru 30 as an
assembly from vehicle.
15.
Remove two nuts (21), bolts (22)
and washers (23, Figure 10-9).
16.
Separate and remove pump assembly
(24) and bracket (25).
17.
Remove hoist and sling.
18.
Remove four mounts (26) from
bracket (25).
19.
Remove connector (27) and
preformed packing (28) from pump
assembly (24). Discard preformed
packing (28).
20.
Remove connector (29) and
preformed packing (30). Discard
preformed packing (30).
Go to Sheet 4
10-10
WARNING
Figure 10-9.
Figure 10-8.
