TM 5-3805-261-34
HYDRAULIC SYSTEM MAINTENANCE.
10-3.
Hydraulic Pump Assembly and Mounting.
(Sheet 2 of 7)
REMOVAL
1.
Remove four bolts (1), washers
(2) and two flange halves (3,
Figure 10-6).
NOTE
All hose and tube assemblies
must be tagged before
disconnecting to aid in
installation. Cap all hose
and tube ends to prevent
contamination.
2.
Remove hose assembly (4) from
pump assembly (24).
3.
Remove and discard preformed
packing (5).
4.
Disconnect hose assemblies (6 and
7) from front of pump assembly
(24).
5.
Disconnect hose assemblies (8 and
9) from bottom of hydraulic tank.
6.
Remove hose assembly (9) from
combination valve.
7.
Disconnect hose assembly (10)
from top of pump assembly (24).
8.
Remove four bolts (11) and
washers (12, Figure 10-7).
9.
Disconnect hose assemblies (13
and 14).
10.
Remove tee (15).
11.
Remove four bolts (16), clip
(17), flange (18), tube assembly
(19) and preformed packing (20).
Discard preformed packing (20).
Go to Sheet 3
10-9
Figure 10-6.
Figure 10-7.
