TM 5-3805-261-34
REAR AXLE MAINTENANCE. (cont)
5-25.
Tandem Drive Chain Assembly. (Sheet 2 of 4)
REMOVAL
NOTE
The following is a maintenance
procedure for one right
tandem drive chain assembly.
The maintenance procedure for
the remaining right chain and
the left tandem drive chain
assemblies is identical.
1.
Remove four bolts (1), washers
(2), cover (3) and gasket (4,
Figure 5-146) from top of tandem
housing on right axle, rear
frame. Discard gasket (4).
Remove all gasket material from
mounting surfaces.
2.
Remove two bolts (5), washers
(6), cover (7) and gasket (8)
from outer side of tandem
housing. Discard gasket (8).
Remove all gasket material from
mounting surfaces.
3.
Remove two bolts (9), washers
(10), cover (11) and gasket (12)
from inner side of tandem
housing. Discard gasket (12).
Remove all gasket material from
mounting surfaces.
4.
Turn spindle wheel until master
link of chain assembly appears.
5.
Remove and discard two cotter
pins (13, Figure 5-147).
6.
Using puller assembly and two
legs, remove bar (14).
7.
Using puller assembly and two
legs, remove link (15).
Go to Sheet 3
5-118
Figure 5-146.
Figure 5-147.
