TM 5-3805-261-34Section I.BRAKES TROUBLESHOOTING.6-1.GENERAL INFORMATION.This section lists the common brake malfunctions which may occur during theoperation of the 130G Grader. You should perform the tests, inspections and corrective actions in the order listed. Followthe troubleshooting procedures listed below step-by-step until you can go no further.6-2.BRAKES TROUBLESHOOTING PROCEDURES. This section cannot list all possible malfunctions, nor can it listall possible tests, inspections or corrective actions. If a malfunction is not listed, contact your supervisor.BRAKES TROUBLESHOOTING AND MAINTENANCE PROCEDURES.MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTIONa.AIR COMPRESSOR PASSES EXCESSIVE OIL, INDICATED BY OIL SEEPING FROM AIR STRAINER.Step 1.Check for restricted air intake. Check engine air cleanerassembly and compressor air inlet line for restrictions.Remove restrictions from the intake system, if necessary. Refer toTM 5-3805-261-20.Step 2.Check for restricted oil return line. Look for kinks, bends orrestrictions in oil return line. Refer to paragraph 6-9. Oildrain passages in compressor and engine must be alined andunobstructed.If oil return line is clear, go to step 3.Step 3.Check for poorly filtered inlet air. Check for dirty engineair filters. Check for damaged intake strainers, gaskets, etc.If filters are dirty--replace. Refer to TM 5-3805-261-20. Ifintake parts are damaged--replace. Refer to paragraph 6-13.6-2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
