TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE. (cont)
3-50.
Governor Controls. (Sheet 9 of 21)
REMOVAL (cont)
68.
Remove nut (94) and bolt (95, Figure 3-168).
69.
Remove lever (96)
70.
Remove nut (97), washer (98) and bolt (99) from
items 112 thru 129 as an assembly.
71.
Support items 102 thru 111 as an assembly under
right side of operators compartment.
72.
Remove two bolts (100), washers (101) and items
102 thru 111 as an assembly.
73.
Remove key (102, Figure 3-169).
74.
Remove nut (103) and bolt (104).
75.
Remove lever (105) and key (106) from shaft (107).
76.
Remove shaft (107) from bracket (111).
77.
Remove two nuts (108) and bolts (109).
CAUTION
Removal of bushing may cause destruction
of bearing. Remove bushing only if inspection
indicates replacement is necessary.
78.
Inspect bushing (110). Replace if cracked, broken,
grooved or worn.
79.
Using suitable driver and hammer, remove bushing
(110), if necessary and bracket (111).
Go to Sheet 10
3-176
Figure 3-169.
Figure 3-168.