TM 5-3805-261-34
FUEL SYSTEM MAINTENANCE.
3-30.
Governor Controls. (Sheet 6 of 21)
REMOVAL
38.
Remove four nuts (42), washers (43), three
clips (44), two plates (45) and clamps (46,
Figure 3-160) from lower, left and right sides
of articulation area.
39.
Separate cable (61) from left and right clamps
(46) and pull cable (61) through articulation area.
40.
Remove bolt (47), washer (48) and clip (49) from
under right side of operator’s compartment.
41.
Remove bolt (50), washer (51) and clip assembly
from under right side of operator’s compartment.
Leave clip assembly mounted to hydraulic hose.
42.
Remove five bolts (52), washers (53), cover (54)
and gasket (55). Discard gasket (55). Remove all
gasket material from mounting surfaces.
43.
Remove bolt (56) and washer (57).
44.
Separate rod end (58) and lever (64).
45.
Loosen nut (59).
46.
Remove rod end (58) and nut (59).
47.
Remove nut (60) from inside housing (66).
48.
Remove cable (61) from vehicle.
Figure 3-160.
Go to Sheet 7
3-173
