FUEL SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34

FUEL SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_240

FUEL SYSTEM MAINTENANCE. (cont) - TM-5-3805-261-34_242

TM-5-3805-261-34 Grader Heavy Road Motorized (Caterpillar Model 130 G) Manual
Page Navigation
196

TM 5-3805-261-34 FUEL SYSTEM MAINTENANCE. 3-30. Governor Controls. (Sheet 2 of 21) REMOVAL 1. Remove and discard cotter pin (1, Figure 3-152) from fuel injection pump governor on right side of engine. 2. Remove pin (2). 3. Separate rod end (7) and lever (12). 4. Remove and discard cotter pin (3) from inner, right side of dash panel in engine compartment. 5. Remove pin (4). 6. Separate rod (5) and lever (16). 7. Remove items 5 thru 9 as an assembly from vehicle. 8. Loosen nut (6, Figure 3-153). 9. Remove rod (5) and nut (6) from link (9). 10. Loosen nut (8). 11. Remove rod end (7), nut (8) and link (9). 12. Using scriber, matchmark lever (12) and fuel injection pump governor shaft to aid in aligning lever (12, Figure 3-154) on fuel injection pump governor shaft in installation to fuel injection pump governor. 13. Remove nut (10) and bolt (11). 14. Using screwdriver, remove lever (12) from fuel injection pump governor shaft. Go to Sheet 3 Figure 3-154. Figure 3-153. Figure 3-152. 3-169

Privacy Statement
Press Release
Contact