TM 5-3805-261-34ENGINE MAINTENANCE.3-16.OilPumpandLines. (Sheet 5 of 6)INSTALLATION13. Position new gasket (11) and bell (10) on oilpump (18).14. Install lock (9) and two bolts (8). Bend lock (9)tabs up against bolt (8) heads.15. Locate top center of compression stroke ofnumber one cylinder on engine. Refer toparagraph 3-12.16. Aline two balancer shafts on bottom of engine.Turn balancer shafts so that the flat sides ofthe shafts face the opposite direction of oil panplate. Install two 3/8-16NC 1-1/2 inch longbolts (1, Figure 3-74) through oil pan plate andinto each of the balancer shafts. Tighten thebolts until they touch the bottom of the holes ofthe balancer shafts, then loosen 1/2 turn.Go to Sheet3-95Figure 3-74.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
