TM 5-3805-261-34
ENGINE MAINTENANCE. (cont)
3-12. Rocker Arm Assembly. (Sheet 10 of 13)
INSTALLATION (cont)
33.
Lubricate eight lifters (4) and push rods (3)
with clean oil and install in cylinder head in
original positions. Install falt end of eight lifters
(4) first and ball end of push rods (3) to mate
with lifters (4, Figure 3-47).
34.
Cover threads of one bolt (1) with tape to
protect preformed packing (46) in bracket (45).
35.
Install washer (2) and bolt (1) with taped
threads through bolt hole in bracket (45), then
remove tape.
36.
Install three washers (2) and bolts (1) through
brackets (34, 23 and 12).
37.
Apply anti-seize compound to threads of four
bolts (1).
38.
Install items 55 thru 5 and 2 and 1 as an
assembly.
CAUTION
Adjusting screws must be loose and
seated on push rods before installing bolts.
39.
Tighten four bolts (1) in sequence (Figure 3-
61). First tighten to 115 ft-lb torque, then
tighten to 185 ft-lb torque. Finally, repeat 185
ft-lb torque tightening sequence.
Go to Sheet 11
3-74
Figure 3-61.
Figure 3-47.
